Connect-Tek USB-2 Spécifications Page 88

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 441
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 87
Commands Listed in Alphabetical Order
Group
Vertical
Syntax
AUXin:PRObe:RESistance?
Examples
AUXin:PRObe:RESistance? might return :AUXin:PR OBE:RESISTANCE
1.0000E+6
indicating that the input resistance of the probe attached to the front
panel Aux In connector is 1 M.
NOTE. This query will return 0.0 if no probe is attached or the attached probe
does not report the
input resistance.
AUXin:PRObe:SIGnal
This command changes the input bypass setting on VPI probes that support input
bypass, for example the TCP0001. If sent to a probe that does not support input
bypass, it is ignored.
Group
Vertical
Syntax
AUXin:PRObe:SIGnal {BYPass|PASS}
AUXin:PRObe:SIGnal?
Arguments
BYPass sets the probe to Bypass mode.
PASS sets the probe to Pass mode.
AUXin:PRObe:UNIts? (Query Only)
Returns a string describing the units of measure of the probe attached to the Aux
In input.
Group
Vertical
Syntax
AUXin:PRObe:UNIts?
Examples
AUXin:PROBE:UNITS? might return: :AUXin:PROBE:UNITS “V indicating
that the units of measure for the attached probe are volts.
2-72 MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual
Vue de la page 87
1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 440 441

Commentaires sur ces manuels

Pas de commentaire