Connect-Tek USB-2 Spécifications Page 148

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 441
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 147
Commands Listed in Alphabetical Order
Group
Waveform Trans
fer
Syntax
DATa:STARt <NR1>
DATa:STARt?
Related Commands
CURVe, DATa, DATa:STOP, WFMInpre:NR_Pt, WFMOutpre:NR_Pt?
Arguments
<NR1> is the rst data point that will be transferred, which ranges from 1 to the
record length. Data will be transferred from
<NR1> to DATa:STOP or th
erecord
length, whichever is le ss. If
<NR1> is greater than the record length, the last
data point in the record is transferred.
DATa:STARt and DATa:STOP are order independent. When DATa:STOP is
greater than DATa:STARt, the values will be swapped internally for the CURVE?
query.
Examples
DATA:START? might return :DATA:ST ART 214 indicating that data p oint 214 is
the rst waveform data point that will be transferred.
DATA:START 10 species that the waveform transfer will begin with data point 10.
DATa:STOP
Sets or returns the last data point that will be transferred when using the CURVe?
query. This command allows for the transfer of partial waveforms from the
oscilloscope.
Changes to the record length value are not automatically reectedinthe
DATa:STOP value. As record length is varied, the DATa:STOP value must be
explicitly changed to ensure the entire record is transmitted. In other words, curve
results will not automatically and correctly reect increases in record length if
the d istance from DATa:STARt to
DATa:STOP stays smaller than the increased
record length.
Group
Waveform Transfer
Syntax
DATa:STOP <NR1>
DATa:STOP?
Related Commands
CURVe, DATa, DATa:STARt, WFMInpre:NR_Pt, WFMOutpre:NR_Pt?
2-132 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual
Vue de la page 147
1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 440 441

Commentaires sur ces manuels

Pas de commentaire