Connect-Tek USB-2 Spécifications télécharger pdf (Page 27)

100

101

Command Groups

This manual lists the MSO/DPO2000B and MSO/DPO2000 series IEEE488.2

commands in two ways. First, it presents them by functional groups. Then, it lists

them alphabe

tically. The functional group list starts below. The alphabetical

list provide s detail on each command. (See page 2-59, Commands Listed in

Alphabetical Order.)

Acquisition Command Group

Use the commands in the Acquisition Command Group to set up the modes and

functions that control how the oscilloscope acquires signals input to the channels,

and processes them into waveforms.

Using the commands in this group, you can do the following:

Start and stop acquisitions.

Control whether each waveform is simply acquired, averaged over successive

acquisitions of that waveform.

Set the controls or conditions that start and stop acquisitions.

Contr

ol acquisition of channel waveforms.

Set acquisition parameters.

Tabl

e 2-13: Acquisition Commands

Command Description

ACQuire?

Ret

urns acquisition parameters

ACQuire:MAXSamplerate?

Ret

urns the maximum real-time sample rate

ACQuire:MODe Sets or returns the acquisition mode

ACQuire:NUMACq? Returns number of acquisitions that have

occurred

ACQuire:NUMAVg Sets or returns the number of acquisitions for

an averaged waveform

ACQuire:STATE Starts or stops the acquisition system

ACQuire:STOPAfter Sets or returns whether the acquisition is

continuous or single sequence

MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-11

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 440 441

Commentaires sur ces manuels

Pas de commentaire

Connect-Tek USB-2 Spécifications Page 27

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau Connect-Tek USB-2