Connect-Tek USB-2 Spécifications Page 152

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 441
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 151
Commands Listed in Alphabetical Order
Arguments
ALWAYS continu
es looping until the self tests (diagnostics) are stopped via the
front panel or by an oscilloscope command.
FAIL causes lo
oping until the rst self test (diagnostic) failure or until self tests
(diagnostics) are stopped.
ONFAIL caus
esloopingonaspecic test group as long as a FAIL status is
returned from the test.
ONCE execut
es self test (diagnostics test) sequence once.
NTIMES runs “n” number of loops.
Ex
amples
DIAG:LOOP:OPTION ONCE runs one loop of self tests.
DIAg:LOOP:OPTion:NTIMes
Sets the self-test loop option to run N times.
Group
Calibration a nd Diagnostic
Syntax
DIAg:LOOP:OPTion:NTIMes <NR1>
DIAg:LOOP:OPTion:NTIMes?
Arguments
<NR1> is the number of self-test loops.
Examples
DIAG:LOOP:OPTION:NTIMES 3 sets the self-test loop to run three times.
DIAG:LOOP:OPTION:NTIMES? might return :DIAG:LOOP:OPTION:NTIMES 5,
indicating that the self-test loop is set to run ve times.
DIAg:LOOP:STOP (No Query Form)
Stops the self-test at the end of the current loop.
Group
Calibration a nd Diagnostic
Syntax
DIAg:LOOP:STOP
Examples
DIAG:LOOP:STOP stops the self test at the end of the current loop.
2-136 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual
Vue de la page 151
1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 440 441

Commentaires sur ces manuels

Pas de commentaire