Connect-Tek Transa PRO 17 Manuel d'instructions télécharger pdf (Page 119)

Input Setup

ounter Mode (section 4.2.3)

5.3 ction (section 4.2.3.1)

ent to increase counts in a forward

ll be utilized. The instrument will be set to count

h the Direction Bit High.

5.3 Units (section 4.2.3.1)

set to react to the raw A

5.3.4.4. Logic Low & High(section 4.2.3.2)

ow = 0.6 volts, High = 2.6 volts (TTL)

t of

n) must be normalized or

(inches).

l 94,000 pulses/inch

• r multiplied by 1/94,000

• is entered in exponential notation. 0.0000106 = 1.064 e-5

5.3.4.6. Units(section 4.2.3.4)

Enter units as “Inches”

5.3.4.7. Counter Type (section 4.2.3.5)

Select Up

5.3.4.1. C

All setup will be performed in Counter mod

.4.2. Dire

Direction is utilized to allow the instrum

(target cw) direction and decrease counts in a reverse (target ccw)

direction. Since an AI-TEK Bi-directional sensor is being used, the

direction logic signal wi

up in t e forward (target cw) direction with

.4.3. Equation &

No equation is being utilized and the instrument is

input. No units are applied.

Logic L

5.3.4.5. Normalization (section 4.2.3.3)

In order for the instrument to display and react to linear displacemen

the stage, the motor rotation (pulses per revolutio

mathematically altered to linear units

• (94 pu ses/revolution) x (1000 revolutions/inch)=

Therefore the input must be divided by 94,000 o

(0.00001064) to read in inches.

Normalization

107

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 132 133

Pas de commentaire

Connect-Tek Transa PRO 17 Manuel d'instructions Page 119